VEGA USER GUIDE
8
OPERATION
1. Disconnect the light source from the mains supply.
2. Tilt the light source on its side and remove the screw from the base as shown below.
3. Slide the access cover down to remove and set the cover and screw aside.
4. Ensure DIP switch 10 (top) is set to OFF as shown below.
5. Set the address required as detailed in the address table, overleaf.
6. Replace access cover and securing screw,
SETTING THE DMX ADDRESS
Note:
for DMX control
operation to work, dip
switch 10 must be in the
off position.
See the table and diagram on the following page for instructions on setting the DMX address
using dip switches.
Summary of Contents for Vega SLP-2700M
Page 15: ...15 UFO LIGHTING NOTES...
