Nova Light Source Range
4
CONNECTIONS
There are 3 connections required – the fibre port, the mains supply cable and
the DMX control cable. The fibre port should be connected first. Connect and
secure the fibre optic connector into the green collar and secure using the M5
locking screw.
Connect the IEC power cord into the Desk Top PSU and plug the mains plug
into the electrical supply socket. Switch on power. The LED Indicator will
illuminate and the light source is ready for use. If no light is produced consult
the TROUBLESHOOTING section.
For DMX control connect up the DMX control cables to the XLR sockets on the
rear of the Light Source. The pin out details for the plugs are shown below.
RJ45 CONNECTIONS
Note:
It is recommended that a 120ohm terminating resistor be
connected across DMX+ and DMX- on the last light source
on the DMX universe or cable run
Pin No
1
2
3
4
5
6
7
8
Colour
White
Orange
Orange
White
Green
Blue
White
Blue
Green
White
Brown
Brown
Function
DMX+
(HOT)
DMX-
(COLD)
Spare
Spare
Spare
Spare
Ground
Ground
DMX-XLR
equivalent
Pin 3
Pin 2
Pin 1
Pin 1
