75
74
4. Insert the water tank into the coffee maker. Make sure it is fitted correct-
ly.
5. Plug the coffee maker to the mains.
6. Place a container underneath the coffee and steam outlet nozzles.
Height of coffee outlet nozzles can be adjusted moving them upwards and
downwards.
7. Touch the icon to switch the coffee maker on. Rinsing process will start
automatically.
8. Indicators of the icons will light up and go off
alternatively.
After a time, water will start flowing out through
the nozzles.
9. Once the rinsing process has finished , all the
indicators will light up permanently.
10. Remove the container placed underneath the nozzles and empty it.
Never drink water collected after
rinsing process!
11. After rinsing, the coffee maker is ready to be used.
Notes:
- Automatic rinsing process will be carried out each time the coffee maker is plugged in to the mains,
or when the coffee maker has cooled down after having prepared a drink. Duration may vary depending
on the temperature of the system. Starting from cold, duration is about 45 seconds.
- The coffee maker is tested at the factory using coffee and water. Although the unit has been carefully
cleaned, it is possible that some water and coffee residues remain. It is recommended to carry out this
rinsing process several times before first use.
To assemble the filter, proceed as follows:
1. Rinse the new filter in a water container.
2. Firmly insert the filter into the water tank connec-
tion in an upright position.
Very important: make sure that the rubber gasket is
correctly inserted in the coupling on the bottom of
the water tank
3. It is recommended to replace the filter every 2 months.
Replacement should be carried out preferably just after having carried out a
descaling process. Turn date indicator on the top of the filter to show the re-
placement month on the left side of the window. On the right side it is shown
the month when the filter should be replaced.
4. Program the coffee maker to indicate that the filter is mounted (see section “Activating water filter”).
5. Then, dispense a cup of hot water to rinse water circuit.
2. BEFORE FIRST USE
1. Remove the water tank (6). Take it from the handle (7) and pull it out.
2. Wash the water tank under the tap.
3. Fill the water tank.
Never fill beyond the level for maximum filling
(MAX)!
