UFESA AS3100, Instruction Manual

Page: 12 / 38

4
Place the filter cover in such a way that the two
protrusions situated in the lower part of the cover
are inserted into the holes in the body of the vacuum
cleaner, and then press the filter cover to snap the
fastening in the body shut. A characteristic “click”
signalizes the filter cover has been properly installed.
Always replace a damaged microfilter
with a brand new, original one.
After-work procedures, cleaning
and maintenance
1
Press the on/off button to stop the vacuum
cleaner.
2
Remove the plug of the cord from the socket.
3
Wind the cord by pressing the cord winder button
(8) . Hold the cord when doing it to avoid tangling the
cord up or letting the plug hit the vacuum cleaner.
4 Disconnect the telescopic suction pipe from the
nozzle or brush.
5 Disconnect the suction tube from the hose. In order
to remove the telescopic tube from the hose handle,
simultaneously press the lock “A” and pull the tube in
the direction indicated by the arrow.
6
Turn the end of the suction hose counter-clockwise,
and remove the end of the hose from the inlet of the
vacuum cleaner.
7
The vacuum cleaner may be store in a horizontal
position. In order to do this place the hook of the nozzle
brush into the fastening of the nozzle brush situated
at the back of the vacuum cleaner, near the entrance
of the power cord. The hose may stay attached to the
vacuum cleaner as long as it is not bent too much
during storage.
8
If necessary, clean the casing and the chamber
of the vacuum cleaner with a damp cloth (it may be
damped in dishwashing liquid), dry it off, and wipe it dry.
Do not use any scrubbing agents or
solvents.
F
Examples of problems you may
encounter when using the vacuum
cleaner
PROBLEM SOLUTION
A characteristic
fluttering in the
vacuum cleaner is
heard.
● Check the “CYKLON”
dust container and other
accessories. Remove the
reason for the clog-up
or empty and clean the
“CYKLON” dust container.
● Replace or clean the filters.
The vacuum
cleaner works less
efficiently.
Empty and clean the
“CYKLON” dust container,
replace or clean the filters,
check the suction pipe, the
hose, and the nozzle – remove
the reason for the clog-up.
The cut-out of the
wiring system has
been triggered.
Check if there are any other
devices, besides the vacuum
cleaner, plugged into the same
electrical circuit. If the cut-out
is triggered again, have the
vacuum cleaner repaired in
a servicing center.
The vacuum
cleaner does not
work; the body or
the power cord is
damaged.
Have the vacuum cleaner
repaired in a servicing center.
Advice on disposal
Our goods come in optimised packaging. This
basically consists in using non-contaminating
materials which should be handed over to the local
waste disposal service as secondary raw materials.
This product complies with EU Directive
2002/96/EC. The crossed wheelie bin
symbol shown on the appliance indicates that
when it comes to dispose of the product it
must not be included in with household refuse. It must
be taken to a special refuse collection point for electric
and electronic appliances or returned to the distributor
when purchasing a similar appliance. Under current
refuse disposal regulations, users who fail to take