UES HP 07, Operating Manual

Page: 17 / 22

H
P 07 Operating Manual
17
UES AG · Roemerstraße 15 · D-47809 Krefeld
Tel.: +49 (0)2151-72950 · Fax: +49 (0)2151-7295578 · info@ues-int.net · www.ues-int.net
Technical Data
Modular system for three types of manual hot melt application:
• Spot/bead - H300 P
• Needle seat - H300 P-NA
• Spraying application - H300 P-SP
The basis body of the gun is the same for all three types. The desired type of handgun is constructed by
exchanging the module and adding extern components.
The storage takes place in construction groups so that the assembly can take place in short time.
Weight 1.15kg with cord set without hose
Measurement 220 x 210 x 38 mm
Voltage 230V AC, 50Hz
Power 150W
Start time 15 min to set temperature
Degree of protection IP22
Housing
PA6.6GFK30 heat resistant and isolating
Temperature 200 °C long run, 230 °C short term
Work pressure 40 – 50 bar, short term max. 75 bar
Flowing through without nozzle 0.451/min at 1000mPas
Needle stroke depending on the module 2.4 mm max. linear opening at the entire stroke
Heating transmission of the heat at the entire length of the glue block, 2 sensor positions
for differentiated heating characteristics
Sensor Ni120 or Pt100, FeKo, NTC Dm4-0.05x15 mm cord set length 500 mm
compatible to UES, Nordson
®
, Meltex
®
, Robatech
®
The standard installation of each handgun includes the electrical release and opening and closing appli-
ance.
Exchange of the module should only take place when the trigger is pulled to the end.
The adjustment of the release depends on the pressure. 0,5mm clearance between housing and trigger
(see drawing 6.3). In this position the switch must not yet be switched.
Through connectors the cord set can be exchanged, e.g. connection of the UES hose for AD31.
The length of the standard needle seat is 40 mm- reaching from glue block to nozzle tip.
The STOP position of the safety lever avoids an unintentional release of the trigger.
Spraying application
For spraying application you need additionally compressed air at your handgun.
• e.g. usage hose with intregrated spray air tube (e.g. 2,4m hose; UES part no. 100292)
• handy appurtenance: Spray air control HP 07 – not operated grip shift switched off the air for the gun
(inline micro switch) (UES article: 100493)