PIPELINE CLEANING & TELEVISING EQUIPMENT
PIPELINE CLEANING & TELEVISING EQUIPMENT
Camera Controls
The camera control (Fig 2.7)
portion contains the necessary
controls for operation and
status of the system. The
following is a description of
each component along with its
associated functions.
Power Switch
There is only
one toggle switch that controls
both AC and DC power to the
unit. One indicator light next to
the power switch indicates the
“ON” condition.
AC Power (Switch Reverse)
Controls power to the system
when the 120-volt line cord is being used.
DC Power (Switch Forward)
Controls power to the system when the 12-volt DC
automotive plug or 14.4V battery pack is being used. See
the operations section of this manual for further details.
Light Intensity Control
The light intensity control varies the camera light output. The
light is increased when the control is turned clockwise. The
lighthead voltage can reach up to approximately 12V.
-14-
Figure 2.7
-33-
AC Battery Charger (Trickle)
This battery charger is built to
charge UEMSI branded bat-
teries at a trickle rate. It does
not have a DC power option.
The charger plugs into the 2.1
mm jack built into the top of
the battery pack. Each time
the charger is plugged into
120VAC it goes through a
lighting cycle where the LED
flashes red and green twice.
(Fig 4.6) Once a battery is
connected it will illuminate red to indicate a charging state.
The battery is fully charged after 8-10 hours and the LED will
illuminate green.
AC/DC Battery Charger (Quick)
This charger has two battery bays for multiple battery charg-
ing. This charger operates off of 120VAC or a 12VDC ciga-
rette lighter. This charger takes approximately two hours to
fully charge a battery. If two batteries are inserted into the
charger at the same time only one battery will fully charge,
followed by the second battery. The charger will not change
the batters simultaneously.
(Fig 4.7)
Figure 4.7
Figure 4.6
