WirelessHART Toxic & Combustible Gas Detector
IM_TCD50-05
www.ueonline.com/vanguard
14
2.6.3 Wall Mounting
Wall mounting could affect the signal strength of the device
1. Remove hardware from packaging (see Figure 21).
2. Hold mounting bracket plate [3] against wall/flat surface and screw tightly into place using (4x) mounting holes (0.40” dia.).
Note:
Mounting screws [6] not UE provided.
3. Mount device by hooking onto top pin of mounting bracket plate (see Figure 22).
4. Push attached pin [5] through bottom holes to secure device to the bracket (see Figure 23).
2.6.4 Device removal from mounting bracket plate
Removing the device from the mounting bracket plate for maintenance or calibration is simple.
1. Pull attached pin [5] through bottom holes using the pull ring.
2. Pull device up and unhook from mounting bracket plate [3].
Figure 21
Figure 22
Figure 23