15
MAINS CABLE
CONNECTED
CHARGE CABLE
CONNECTED
STATUS LED ON
BATTERY
NO
NO
OFF
YES
NO
Green
YES
YES
Red or yellow, charging
YES
YES
Green, fully charged
CHARGE GAUGE
Press the charge gauge button (
item 2 in Image 5
) to test the state of the battery charge. This
is approximate only and the most accurate results are after 2 minutes of no load.
3.2 Startup
For startup, please see the below sections that instruct you on using either the RRC2040
battery or Tracer.
3.2.1 STARTUP WITH RRC2040 BATTERY
The RRC2040 battery set for the UltraView includes two batteries, a charger, a charger
power supply, and a country-specific power cable.
To start using the battery, and in case you need to attach the battery housing to the
UltraView, please follow the instructions below and see
Image 6
.
After you have attached the battery housing to the UltraView, by open the lid (
item 3 in Image
7
) by turning the knob of the battery housing counterclockwise and insert the battery in to the
battery housing with the connectors at the front and the charge gauge (
item 2 in Image 7
)
facing upwards. Ensure the battery is inserted all the way inside the housing. Close the cover of
the battery and turn the knob clockwise to lock the cover. Press the on/ off button (
item 1 in
Image 7
) at the front of the battery housing to turn on the camera. The LED located on the top
LEDS
STATE OF CHARGE
3 greens, 2 reds
Full
2 greens, 2 reds
Over 50%
1 green, 2 red
Over 20%
2 reds
Less than 20 % (recharge soon)
1 red
Less than 10 % (nearing auto switch-off)
No lights
Empty (recharge within 12 hours)
