18
ALARM ENABLE/DISABLE
While in the
Operation mode
, this function selection will display
Alarm Disabled
if no alarm level has been set. If an alarm
level has been set, it will show the set level in
dB
. To enable the alarm, see
ALARM ENABLE/DISABLE
in the
SETUP
MODE
below.
WARNING: If the alarm value is changed, the new
dB
alarm value will be stored in the record and will overwrite the previous value.
The alarm
dB
level stored in the current record can be viewed in the main display. It can be changed. To do so:
1.
Click down to the bottom of the
Display Panel
until
PRESS ENTER FOR
:… is blinking
2.
Spin to
Alarm
(the
dB
value will be shown)
3.
Click to
Enter
4.
Spin to the desired
dB
alarm level
5.
Click the
Yellow ENTER Button
to exit
GENERIC INFO:
1.
To view
Generic Info
, click the
Sensitivity Control Dial
to the bottom of the Display Panel until
“Press ENTER For”
is
blinking. Spin to
Generic Info
and press Enter.
2.
To enter a test condition:
3.
Spin to
Test
the condition default is
OK
and will blink slowly. If it is necessary to change:
4.
Click with the
SensitivityControl Dial
and the condition (
OK
) will blink rapidly.
5.
Spin to select a condition indication. The choices are;
OK
,
CHK
(for check) and a series of
TR1-TR9
which can be use as
codes for other conditions.
6.
To Set, Click the
Sensitivity Control Dial
(the condition will blink slowly)
7.
Spin to
Temperature
should a Temperature entry be desired
8.
Click on the
Temperature
setting (it will blink rapidly) Spin to the left to select a “100” reading (ex 200, 300) and to the
Right to select a “tens” reading (ex: 50)
9.
Click to set
10. Press
Enter
to store the information or
11. Spin to
EXIT
and click to exit.
Record WAV
To Record a
WAV
(sound file) click the
Sensitivity Control Dial
to the bottom of the
Display Panel
until
“Press ENTER For”
is blinking. Spin to
Record WAV
and press
Enter
.
Be sure the Compact Flash Card is inserted into the slot on the Ultraprobe and keep the Trigger Switch pulled on (or set the
Timed Off mode as described in Setup Menu 16 and 17 to shut off at a pre-determined time, ex: 30 seconds.) or set to Trigger
Off mode (see setup mode 17 Shut Off Mode).
1.
When ready to record, click the Sensitivity Dial and
Hold it in
for the duration of time you wish to record.
2.
When through, release the
Sensitivity Control Dial
.
3.
You can preset the time of recording in Setup Mode 7 for: Manual (as above), 5, 10, 15, 20,25,30 seconds.
4.
Press
Enter
to playback/review the sound you have recorded.
5.
Press
Sensitivity Control Dial
to Continue on to the next screen
6.
Press
Enter
to
Save
the recording or if you do not wish to save the recording, press
Sensitivity Control Dial
to Exit.
7.
When through
saving a recording
, press the
Sensitivity Control Dial
to Exit.
Press ENTER GENERIC
To store
001
Test Results: OK
Temperature: 350 F
60 dB
40 kHz
S=69
RT
Press ENTER
for Generic Info
60 dB
40 kHz
S=69
RT
Press ENTER
for Alarm
Set Alarm Value
Current Alarm Value
( 120 dB )
Press ENTER
for Setup Menu
