ANNA-B4 series - System integration manual
UBX-21000517 - R03
Contents
Page 54 of 74
C1-Public
In case, where the final product will be installed in locations where the end-user is not able to see the
FCC ID and/or this statement, the FCC ID and the statement shall also be included in the
end product manual.
FCC and IC IDs
Model
FCC ID
ISED certification number
ANNA-B402
TBD
TBD
ANNA-B412
TBD
TBD
Table 20: FCC and ISED certification number for the ANNA-B4 modules
End product compliance
7.3.6.1
General requirements
•
Any changes to hardware, hosts or co-location configuration may require new radiated
emission and SAR evaluation and/or testing.
•
Only authorized antenna(s) may be used.
•
Any notification to the end user about how to install or remove the integrated radio module is
NOT allowed.
•
The modular transmitter approval of ANNA-B4 does not exempt the end product from being
evaluated against applicable regulatory demands. The evaluation of the end product shall be
performed with the ANNA-B4 module installed and operating in a way that reflects the
intended end product use case. The upper frequency measurement range of the end product
evaluation is the 5th harmonic of 2.4 GHz as declared in 47 CFR Part 15.33 (b)(1).
•
The following requirements apply to all products that integrate a radio module:
o
Subpart B - UNINTENTIONAL RADIATORS
To verify that the composite device of host and module complies with the
requirements of FCC part 15B the integrator shall perform sufficient measurements
using ANSI 63.4-2014.
o
Subpart C - INTENTIONAL RADIATORS
It is required that the integrator carry out sufficient verification measurements using
ANSI 63.10-2013 to validate that the fundamental and out of band emissions of the
transmitter part of the composite device complies with the requirements of FCC part
15C.
•
When the items listed above are fulfilled the host manufacturer can use the authorization
procedures presented in Table 1 of 47 CFR Part 15.101.
7.3.6.2
Co-location (simultaneous transmission)
If the module is to be co-located with another transmitter, additional measurements for
simultaneous transmission are required.
7.4
Japan radio equipment compliance
⚠
Approvals are pending
Compliance statement
ANNA-B4 series modules comply with the Japanese Technical Regulation Conformity Certification of
Specified Radio Equipment (ordinance of MPT N°. 37, 1981), Article 2, Paragraph 1:
•
Item 19 "2.4 GHz band wide band low power data communication system".