ANNA-B4 series - System integration manual
UBX-21000517 - R03
Contents
Page 52 of 74
C1-Public
RF-exposure statement
7.3.2.1
ISED Compliance
All transmitters regulated by IC must comply with RF exposure requirements listed in
“
RSS-102 -
Radio Frequency (RF) Exposure Compliance of Radiocommunication Apparatus (All Frequency
Bands)
”
. This module is approved for installation into mobile and/or portable host platforms and
must not be co-located or operating in conjunction with any other antenna or transmitter except in
accordance with Industry Canada's multi-transmitter guidelines. End-users must be provided with
transmitter operating conditions for satisfying RF Exposure compliance.
7.3.2.2
FCC Compliance
This device complies with the FCC radiation exposure limits set forth for an uncontrolled environment.
ANNA-B4 modules are approved for installation into mobile and/or portable host platforms and must
not be co-located or operating in conjunction with any other antenna or transmitter
–
except in
accordance with FCC multi-transmitter guidelines. End-users must be provided with transmitter
operating conditions for satisfying RF Exposure compliance.
End product user manual instructions
7.3.3.1
ISED Compliance
☞
License-exempt radio devices shall contain the following (or equivalent) notices displayed in a
conspicuous location
—
either in the user manual, on the device, or both:
☞
This device contains license-exempt transmitter/receiver that comply with Innovation, Science
and Economic Development Canada’s licen
se-exempt RSS(s). Operation is subject to the following
two conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
☞
Under Industry Canada regulations, this radio transmitter can only operate using an antenna of a
type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be chosen in such
a way that the equivalent isotopically radiated power (e.i.r.p.) is not more than that is necessary
for successful communication.
Le manuel d’utilisation des appareils radio exempts de licence doit contenir l’énoncé qui suit, ou
l’équivalent, à un endroit bien en vue dans le manuel d’utilisation ou sur l’appareil,
ou encore aux deux endroits.
L’émetteur/récepteur exempt de licence contenu dans le prés
ent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence
. L’exploitation est autorisée aux deux conditions suivantes:
1.
l’appareil ne doit pas produire de
brouillage.
2.
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.