ANNA-B4 series - System integration manual
UBX-21000517 - R03
Contents
Page 39 of 74
C1-Public
5.
Select
Tools
>
Software Update
.
Figure 18: Software update
6.
Check that the correct COM port is shown in “Settings”.
Select File
and choose the
ANNA-B41X-
CF-<version>.json
file from the unzipped u-connectXpress container.
Figure 19: Select software file
7.
Select
Update
. The module then reboots using the secure bootloader and flashing of both the
SoftDevice and application starts automatically.
5.1.1.2
Updating software with AT commands
☞
You can send AT commands to ANNA-B41 to execute certain tasks over the serial interface, using
open-source terminal emulator software that supports XMODEM, like TeraTerm or ExtraPuTTy.
Alternatively, you can send all AT commands described in this section using the s-center software
in AT mode. The examples given in this procedure have been created and tested on EVK-ANNA-
B41 using TeraTerm. See also the u-connectXpress AT command manual
protocol specification
The bootloader must be running when the software is “sent” to the module. You start the bootloader
using either:
•
AT commands
•
Pressing the SW1 and SW2 buttons simultaneously during a module reset (initiated by setting
RESET_N