Ubisys H1, Manual

Page: 32 / 42

32 Heating Control H1
Chapter 5 | More Functions and Information
4
Display
Button
Schraubring
Drehrad
Batterie-Schutzfolie
100 mm
55 mm
5
Display
Button
Schraubring
Drehrad
Batterie-Schutzfolie
100 mm
55 mm
1. Remove the rotary dial (simply pull it off).
2. Remove the battery cover.
3. Replace the batteries (please ensure correct polarity).
4. Close the battery compartment.
5. Put the rotary dial back on.
5.5 Finding/Binding
Finding/Binding is essentially used to let Zigbee devices communicate with each other – usually when no gate-
way is present. If a gateway is present, it takes over the communication.
At the H1 you have the possibility to configure it as „initiator“ or as „target“ (by selecting the corresponding icon
in the menu).
Example for Finding/Binding (Scenario: Heating control H1 is connected to a wall thermostat):
The H1 is configured as „initiator“:
When an attribute (e.g. setpoint temperature) is changed at H1, a report with the value is generated and sent to
the wall thermostat. In this case, the wall thermostat is the „target“.
The H1 is configured as „target“:
When an attribute (e.g. setpoint temperature) is changed at the wall thermostat, a report with the value is gene-
rated and sent to the H1. In this case the H1 is the „target“.
Example of another scenario:
An H1 (configured as „initiator“) could control further H1s (configured as „targets“) via a „finding/binding“
(without the presence of a gateway), so that when the set temperature on the „initiator“ is changed, the set tem-
perature on the „target“ is adjusted at the same time.
To create a finding/binding, proceed as follows: