Preparing a Head and Battery Unit Tool Tag
Preparing a Head and Battery Unit Tool Tag
The Head and Battery Unit Tool Tag is supplied with a standard cable (wire) length, as shown in
the following figure.
Head and Battery Unit Tool Tag
Before you attach a Head and Battery Unit Tool Tag to a tool, you must cut the wire to the correct
length, depending on your particular requirements.
To prepare the tag, cut the wire to the appropriate length:
1. Determine the required length of the wire. Ensure that you allow sufficient length to
properly terminate and strain-relieve the wires. Cut the wire to the appropriate length, as
shown in the following figure. Discard the plug.
5