Establishing a Link
Adjust the positions of the AP and the CPE to establish a
link. The following section features the airFiber X antenna,
AF-5G23-S45:
Note:
The AP must be aimed first at the CPE because
the CPE does not transmit any RF signal until it detects
transmissions from the AP.
1.
AP
Visually aim the AP at the CPE. To adjust the AP’s
position, adjust the azimuth and the elevation.
Adjust the azimuth:
a. Loosen the two Flange Nuts on the U-Bolt.
b. Rotate the antenna to point towards the other end of
the link.
c. Tighten the two Flange Nuts.
The elevation angle may be adjusted ±15°. Adjust the
elevation angle:
d. Loosen the four Hex Bolts on both sides of the antenna.
e. Pivot the antenna to the desired elevation.
f. Tighten the four Hex Bolts.
