UBI EasyCoder 601 – Installation Instruction
6
PAPER CUTTER KIT, cont'd.
The cutter is activated by
CUT
statements in the UBI Fingerprint
program, see the UBI Fingerprint manual.
Since the cutting edge is situated a longer distance from the
printhead than the tear-off/dispensing edge, the paper feed setup
may need to be adjusted (see “Setup Parameters; Detection” in the
EasyCoder 601 E Technical Manual).
The following values are recommended for cutting between labels
and for variable length strip. In both cases, the start adjustment is
calculated to allow the paper web be pulled back after cutting, so
printing can start directly at the forward edge.
Labels:
Start adjust
- 294
Stop adjust
+ 180
Var. length strip:
Start adjust
- 294
Stop adjust
+ 250
Should you inadvertently have cut through self-adhesive web, you
will have to clean the “knife”, which is a rotating shaft with an edge.
Tilt down the cutter and use a piece of tissue moistened with
isopropyl alcohol, or a similar solvent, to wipe clean the shaft.
CAUTION!
Turn off the power to the printer before cleaning.
Keep fingers away from cutting parts!
Controlling the Cutter
Maintenance