UBI EasyCoder 601 – Installation Instruction
2
❑
Important!
Turn off the main switch and remove the power cord.
❑
Open the printer's front hatch.
❑
Hold the printer firmly and press the front hatch sideways to the
left so the hinges disengage.
❑
Remove the hatch completely.
❑
As standard, the EasyCoder 601 E is fitted with a label-taken
sensor (LTS), which intrudes on the space required by the cutter
and which has no use anyway in connection with cut-off
operation. Before the cutter can be fitted, the LTS must be
removed.
❑
Remove the cover over the left part of the printer. It is held by
four #T10 Torx screws along the lower edge and another four
similar screws at the top.
PAPER CUTTER KIT, cont'd.
Step-by-Step Instructions
Continued!
Front Hatch
Press sideways
F1
Pause
Setup
Feed
Enter
7
8
9
4
5
6
1
2
3
.
0
C
Power
Ready
Error
F2
F3
F4
F5
#T10 Torx Screws
#T10 Torx Screws