Installation and putting into operation
13
printed: 02/2015 Subject to change!
TopLineUserManualKT.docx
4 Installation and putting into operation
In general all Cold Display Cabinets will be packed for safe transport after the final
control in order to reach you properly. Nevertheless we ask you to have a look at the
machine on arrival to detect any transport damages if there are any.
Note!
Visible damages have to be reported immediately!
4.1 Unwrapping
•
Open the carton and take out the wrapping material carefully.
•
Take care that the delivery is complete (see attached freight papers).
4.2 Installation
Place the cabinet in the desired location. Make sure, that is is good visible for your
customer to ensure good foodpresentation and successfull sales.
Take care of the following points:
Place the Cabinet dry.
Take care that the Cabinet has to be placed in well ventilated rooms! Mounted in
a cut out of a counter with air openings (min. air inlet opening of 419,1mm by
215,9mm and discharge opening of 482,6 by 228,6mm). Fitted with silicon all
around the cabinet.
Avoid to place the cabinet close to any heat-sources (heaters, radiators, sun-
beams and the like).
The cooling compartment (condenser and compressor) below the cabinet must be
well ventilated after installation.
The cabinet (with or without stand) has to be placed on a horizontal level. Use a
spirit level if necessary.
Take care that both sides have at least 10cm clear space to enable cleaning of
the sideglasses.
There has to be enough free space to load, unload, clean and maintain the unit.
The machine has to be placed so that the complete area around it can be cleaned
easily.
4.3 Electrical connection
Note!
In general, only service technicians of the company: UBERT GASTRO-
TECHNIK GMBH or service technicians of your responsible service partner are al-
lowed to perform el. connection and other service! All national and lokal rules and
regulations concerning electricity, fireprotection and the like have to be concidered.
During any servicing, take care that the unit is disconnected from the mains! Not pay-
ing attention may result in injury!
Please learn the electrical and technical data of your unit from the nameplate.
Check whether your lokal electrical power supply is in accordance with the values on the name
plate.
The power supply needs to be manufactured from heat resistant, flexible cable. It is to be routed
to prevent any contact to hot parts.
The unit is to be connected to the power supply either by means of an appropriate plug or if con-
nected permanently, a switch (interupting all poles) is to be provided. In case of an emergancy
the power supply must be interuptable immediately.
For further information please see the wiring diagram (below).
Note!
After finishing any installationwork, maintainance or repair check whether the ground
wires are connected properly to the casing.
