7
13
12
Step O:
Step P:
Step Q:
1.Install the support bar.
2.Tighten the support bar with two screws on the panels. Make sure to mount
rubber bumpers to avoid breaking the glass panels,then tighten the bar on the
wall bracket.
1
.
Insert glass panels into their respective tracks(F) .Do not fully
tighten hardware as further adjustments may be required.
Attention:For your safety, this step must be carried out by at least 2 people.
2
.
Put the glass panels on the base ,then proceed with installation
using screws( )and caps( ) on screws( ).
1
.
Put the two adjustable glass clips(G) into the bar.
2
.
Place the support bar(H) on the top of glass panels.
3
.
Use a p
to mark the hole position and drill the hole.
.
emove the support bar
.
5
.
Insert the wall plugs
into the holes using a hammer.
.
Connect the wall bracket(I) on the wall with screws.
encil
4
R
( )
6
1190mm
5
m
6
8
m
1190
685
Φ
8mm
Step N:
Notes:
1
.
Make sure to have a distance of 46.85" (1190 mm) from the left side
wall to the inside edge of aluminum track.
2
.
Make sure to have a distance of 26.97" (685 mm) from the right side
wall to the inside edge of aluminum track.
3
.
Make sure tracks (F) are perfectly aligned vertically and mark the track holes positions
.
4
.
Remove tracks (F) from wall and make sure that the distance
is correct.Then drill holes at the marked locations.
2
.
Continued
2
.
Continued
2
.
Fixed
panel installation
glass
F
I
G
H
I
G
D
E
D
Φ
8mm
5
ST4
*
30
Ref
3
Ref
6
Ref
F
F
6X
F
F
6X
6X
3
6
3
5
Ref
1X
ST4
*
30
3
Ref
1X
5
7
Ref
1X