UBERHAUS DESIGN 98495003, Operator'S Manual

Page: 9 / 20

14 15
A
G
P
D
P
G
H
7A
7C
3.2mm
Note: The panels (G & P) may be adjusted by inserting them to the required depth in their
corresponding rails.
A. Verify the level and that the door (H) opens and closes properly. Adjust panels if
required ( & ) by increasing or reducing the gap A.
7B. According yo the drawing,drill three 3.2 holes.
7C. Assemble the panels ( & ) with the tracks by placing the screws (1), then install the
decorative screw caps (5) as shown in the illustration.
7
G P
mm
G P
3-
3.2
10mm
1
0
m
0
m
m
10
0m
Glass
Middle
Inside
Outside
7B
Installing the track screws
J
H
H
I
8A
8B
8C
8A. Prepare the assembly of the two handles(I & J) .
8B. Install the handle (J) as shown and make sure the horizontal handle (J) is inside the
shower. Hold the handle(J)and make sure the screw of handle(J) is fixed against the inner
side of the installation hole,then turn around the handle(I).
Note: The washers and the PVC glass protection gasket have to be mounted on each side on
the door to protect the glass.
8C. Install the handle (I) by hand and make sure to place the PVC glass protection gasket
Installing the door handle
16 17
9A
9B
9C
NOTE: Before installing glass support clips (L),check that doors close and open easily.Minor
adjustments can be required to have a smooth running.
9A. Place rear bracket (L) and one rubber gasket centered in the notch as illustrated and
mark location of hole to drill on shower base.
9B. Remove glass support bracket and rubber gasket.
Drill a hole in the shower base using the drill bit size
φ
.
9C. Add a drop of silicone to the drilled hole; put back the rear bracket and the rubber seal
and tighten using the screw (2), then, place the front bracket and the rubber seal and tighten
using the Allen key (8).
9D. Repeat the same operations to install the second bracket on the other side.
3.2mm(1/8")
Add a drop of silicone
to the drilled hole
before installing screw
and bracket
# 4
Installing glass support brackets
N
N
10A
10B
10A
10B
N
N
10A. Install the aluminium (N) and plastic connectors(S1&R1), by placing the open mouth of
the plastic parts into the panel(G&P) . Then drilling the 3.2 hole aimed at the elliptical hole of
plastic parts by Drill.
10B. Tighten the screws(1) on the plastic parts(S1 & R1) with a screwdriver,and then install
decorative caps.
NOTE:The plastic parts(S2 & R2) are for the installation of shower in a left-to-right direction.
Installing connectors aluminum
R1
S1
R1
S1 S2
R2
H
H
J
I
3.2mm
3.2mm
J
mm
ou
t
20
mm
Ab