UAV-1004234-001, AV-30-E, Installation Manual
50
Rev C
4.
Click the left button under “Done” when completed. Once complete the
red flag will extinguish. If the calibration failed, please complete again.
The AV-30 will retain all calibration unless a hard reset is accomplished.
13.2.4
OAT Interface
If an Outside Air Temperature (OAT) probe is connected, utilize the display
customization guidance provided in the Pilots Guide to configure the display
to show OAT in at least one textual display field.
Figure 24 - OAT Indicator
Note that OAT calibration is performed in the Setup procedures. This step
only ensures that the OAT probe is detected properly.
13.2.5
GPS Navigator Interface
If a GPS Navigator is connected, utilize the display customization guidance
provided in the Pilot
’s Guide to configure the display to show GPS
navigational data in at least one textual display field.
The image below shows a typical configuration that the pilot may setup.
