UAV-1004234-001, AV-30-E, Installation Manual
47
Rev C
13.2.2
Gyro Calibration
Before using the AV-30 for navigation, please complete the following in AI or
DG modes. At least 15 minutes of warmup is required before AV-30 gyro
calibration. The AV-30 will display a countdown in seconds until the unit can
be calibrated:
1. Before applying power, push and hold the center rotary knob and apply
power. As the splash screen appears, check that a minimum version of
2.1.1 is displayed. Gyro Calibration must be completed on all units with
software version 2.1.1 or later.
2. With the AV-
30 in the AI mode, enter the “Install menu” page by pressing
and releasing the left button repeatedly until the 3
rd
menu is displayed.
The aircraft must be on the ground with no movement.
Figure 19 - Install Mode Selection
3.
It is critical to ensure the aircraft is completely motionless
and on the
ground during the next several steps. The aircraft should be in a hangar
and must not be affected by wind or other sources of aircraft movement.
Do not leave the aircraft during the countdown.
4.
Enter the “Install Menu” again. Rotate to Gyro Cal and push the center
button to choose calibration. Confirm by pressing the right button.
