CM160 Multi-sensor Operations Manual
Doc#: 100-104
ii/3
ii
Version:1.8.0
Revision History
Document Version
Date
Page Number
Change Description
V1.0
NA
First release.
V1.1
12-17
Added, UAV Navigation and MicroPilot
Instructions
V1.2
11
12
13
Changed delay time, added sentence about current
draw
Added new Hookup Diagram
Added Current Recommendation, changed min max
for new gimbals
V1.3
01/10/2010
12
11
14
Updated to CM160-V2, added new cable
configu Voltages
Added new power requirements
Added new Systems Dimensions
V1.4
24/02/2011
11
Updated to new wiring diagram, to include BNC
Connections
V1.5
11/10/2011
Various
Updated address and contact details, packing
information, Test GUI (Vision System), minor
grammatical and spelling corrections
V1.6
03/11/2011
11
Updated diagram and table to include the maximum
allowable voltage when operating the CM160 with
HD sensors
V1.7
27/02/2012
13
Added Mounting caution
V1.8.0
11/06/2013
All
Ported previous document across to new file
template
References
References are specific to both the CM100 and CM160. Please refer only the documents which match
the model of gimbal you are operating.
Reference ID
Document Name
Document Description
[1]
UV400-101_CM160_GimbalPinOuts_2-0-4
CM160 Gimbal Pin Outs
[2]
UV100-103_GTI_QuickStartGuide_1-0-0
Gimbal Interface Quick Start
Manual
[3]
UV300-100_BenchKit_HookUpDiagram_1-0-0
Bench kit Hook-Up Diagram
You are required to read this manual thoroughly and pay attention to voltages and mounting
instructions.
All rights reserved. No part of this book may be reproduced, stored in a retrieval system, or
transcribed, in any form or by any means, electronic, mechanical, photocopying, recording, or
otherwise, without the prior written permission of UAV Vision.
The information in this manual is subject to change without notice and, except for the warranty, does
not represent a commitment on the part of UAV Vision. UAV Vision cannot be held liable for any
mistakes in this manual and reserves the right to make changes.
