PRE-OPERATION CHECKLIST
7
7,500 MAX. RPM
5.5
Verify that the lever is disengaged or released, and the Honda
engine switch and fuel valve lever are in the OFF position. Make sure
blade is completely stopped.
CAUTION:
Running the CC-100 generates heat in the engine, blade and
blade guard. Do not touch these components without wearing proper heat
protecting work gloves.
5.6
Check for missing or loose bolts. Tighten loose bolts and replace
missing bolts before operating machine.
WARNING
Read and understand
operator's manual before
using this machine.
Failure to follow operating
Instructions could result
in injury or damage to
equipment.
Use only diamond blades (steel
centered diamond cutting-off
wheels) with this machine. RPM
rating on blade must exceed
machine max rpm rating. The use
of any other blade could result in
death or serious injury.
5400 MAX. RPM
Avoid injury.
Do NOT operate with
guard removed.
Replace guard before
operating machine.
C1 hazard Communication Sywems. LLLLC
C
M
MO
O--7
74
46
6--0
02
24
41
1
To avoid injury:
Always inspect saw
blades before use.
Replace all cracked or damaged
blades.
Rotating blade
hazard.
Do NOT operate with
guard up.
Keep hands and feet
away.
Engine exhaust
contains poisonous
ccaarrbboonn m
moonnooxxiiddee ggaass..
Breathing it could cause
death.
Operate machine in well
ventilated area.
This product can expose you to chemicals, including NICKEL. When used, serviced, cleaned, or maintained equipment could generate particulates
that contain chemicals, including silica. These chemicals are known to the state of California to cause cancer and birth defects or other
reproductive harm. For more information, visit
www.P65Warnings.ca.gov
4.0
Rules for safer operation
TO AVOID INJURY.
Always inspect saw blades be-
fore use. Replace all cracked
or damaged blades.
Figure 4 - Warning label - inspect blades before use
Surface Prep
Division
P: 877-817- 6687 F: 813-621-7125
Visit us at www.ussaws.com
CAUTION:
The blade depth is approximate and not exact. Many vari-
ables affect the exact blade depth such as the exact diameter of a worn
diamond blade. If an accurate depth must be cut, install the blade to be
used with the engine in the OFF position. Place the CC-100 in a secure
position that allows the blade to overhang and be visibly measured at
full blade depth. An example would be blocking the wheels with the
engine in the OFF position and lowering the blade along side a street
curb. This will allow a measurement from the bottom of the blade to the
top of the curb.
WARNING:
Breathable silica may be generated by use of this product.
Silica can cause severe and permanent lung damage, cancer, and other
serious diseases. Do not breath the dust. Do not rely on your sight
or smell to determine if the dust is in the air. Silica may be in the air
without a visible dust cloud. If air monitoring equipment for silica is not
provided by your employer at your work site, you MUST wear appropriate
respiratory protection when using or servicing the machine. Consult your
employer and OSHA regarding the appropriate respiratory protection.