FORM NO. 56041868 -
5
VACUUM SWITCH (1):
This switch will illuminate when the vacuum
motors are on. The vacuum motors run off of
cord #1
CIRCUIT LOCATOR (2):
When this light is on, it indicates that cord #2
(Identified by the red “H” on the back of the
extractor.) is on a separate line from cord #1.
Cord #2 supplies voltage to the heater allowing it
to heat to the temperature range indicated by the
Heat Control dial (5) on the switch plate.
BYPASS SWITCH (3):
The bypass switch will illuminate when it is
activated and will completely bypass the circuit
locator system. Use the system only when the
circuit locator light will not turn on and you know
each cord is on a separate circuit.
HEAT MODE LIGHT (4):
This light will only illuminate when the heater is
heating and will turn off when it reaches
operating temperature. During normal operation,
the “MODE” light will be on most of the time.
CARPET UPHOLSTERY SWITCH (5):
This rocker switch activates a solenoid valve -
when it is turned to Upholstery - that allows most
of the pump pressure to recirculate back to the
Holding tank. This allows you to clean delicate
material at low psi (about 75 psi). When the
switch is set to Carpet, the pump operates
without the solenoid and provides about 300 psi
to the cleaning tool. The pump runs off of cord
#1. The pump spraying pressure will be
observable at the pressure gauge. This switch
does not light up.
PUMP ON/OFF SWITCH (6):
This switch turns the pump on and off. It will light
up when it is turned on.
CAUTION: WHEN THE BYPASS SWITCH IS ON,
THE CIRCUIT BREAKER CAN TRIP IF BOTH CORDS
ARE ON THE SAME CIRCUIT AND THE BYPASS
SWITCH IS TURNED ON.
FIGURE #1
SWITCH PLATE
NEVER LET YOUR MACHINE OR
YOUR WAND FREEZE
1
3
4
5
6
2
