PAGE 4 OF 5
0222 IH-9975
ATTACHING BRUSH
1. Remove elbow fitting from the clear hose in the
brush neck. (See Figure 14)
Figure 14
2. Route clear hose through the gooseneck and out
the side opening (remove the yellow cap to expose
the opening). Attach brush to the gooseneck by
clicking it into place. (See Figures 15-16)
NOTE: This brush has two clear hoses. Either can
be connected to the main hose, depending on
where the water flow is desired.
Figure 15
Opening
Gooseneck
Yellow Cap
Figure 16
Clear Hose
Opening
Clear Hose
3. Connect brush hose and main hose with the elbow
fitting. (See Figure 17)
Elbow
Fitting
Brush Hose
Main Hose
Figure 17
4. Attach the other end of the main hose to the
ultra-pure resin filter tank. (See Figure 18)
NOTE: The hose connects at the top of the tank,
by connecting the quick-connect fitting. The
fitting at the base of the tank connects to a
garden hose.
Main Hose
Ultra-Pure
Resin Filter Tank
Quick-Connect
Fitting
Figure 18
5. If extension poles are needed while using the pole
with ultra-pure resin filter tank and brush assembly,
the extension adapter must be used. This allows
an extension pole to connect to main pole without
disrupting the hose. The hose will remain internally
routed through main pole but will hang externally
from the extension adapter for the length of
extension pole.
NOTE: Extension adapter is grooved to allow
space for hose. Ensure hose is placed in the
groove when inserting the extension adapter.
ASSEMBLY CONTINUED
Elbow
Fitting
