PAGE 2 OF 6
0522 IH-801
INSTRUCTIONS CONTINUED
MAINTENANCE
4. Thread tape end through the bridge and pull out
over the brush. (See Figure 6)
SETTING FOR MULTIPLE TAPE ROLLS
1. Lift forward end of tape divider plate from slot and
the rear portion of the dispenser and place in the
desired slot that corresponds with the width of rolls of
tape. The combined widths are 2", 1/" and 1".
(See Figure 7)
OPERATION
1. Pull tape out in a slightly downward direction to
ensure thorough moistening. (See Figure 8)
2. When tape is at desired length, pull up against
blade to tear tape from roll.
1-800-295-5510
uline.com
Figure 6
Figure 8
Figure 7
Tape Divider Plate
• Keep tank 2/3 full for best moistening.
• Check water level periodically to ensure satisfactory
moistening of tape.
• Clean brush with soap and rinse once a week to
eliminate adhesive buildup.
• Remove cutting knife and bridge plate monthly for
cleaning.
• Periodically lubricate rolling bearing with a drop of
light oil to ensure efficient operation
