0715 IH-2268
PAGE 5 OF 7
HOW TO REPLACE THE HEPA FILTER CONTINUED
2. Pivot the filter away from the machine and remove.
Install new filter by aligning the tabs at the bottom
of the filter with the slots with the exhaust area of the
cleaner and snap into place. (See Figure 16)
NOTE: This filter is washable and can be
cleaned by rinsing the assembly with warm
water. Be sure the filter is completely dry before
reinstalling in the cleaner.
BRUSH ROLL MOTOR PROTECTION RESET
The cleaner will automatically shut off the brush roll
motor if the brush roll stalls. This will be indicated by a
red light on the handle base near the handle release.
To reset the motor, clear any obstruction to the brush roll
and press the reset switch. (See Figure 17)
HOW TO CHANGE BELT AND SERVICE BRUSH ROLL
CAUTION! Belt pulleys can become hot during
normal use. To prevent burns, avoid touching
the belt pulley when servicing the drive belt.
1. Take out the 2 screws securing the sole plate and
remove. (See Figure 18)
2. Grasp both ends of the brush roll and pull out of the
machine. (See Figure 19)
3. To service the belt, remove five screws from
underneath the base. (See Figure 20)
4. Turn unit over to remove hood and belt. (See Figure 21)
5. At this time, clean any hair or string from brush roll,
removing end caps if necessary.
6. Reverse the steps to reinstall, making sure the new
belt is secure and that the end caps of the brush roll
are properly positioned to fully seat into the base.
HOW TO REPLACE BRUSH STRIPS
a. From the non-pulley end, unscrew locknut (A)
and remove end cap (B). Grasp outer sleeve
and twist bearing retainer (C) counterclockwise
to remove. Pull outer sleeve (D) off of remaining
assembly. Pull out worn brush strip (E) with pliers.
Slide in new same-length brush strip (rounded
end first). Fit track on either side of the brush strip
into the brush roll slot. (See Figure 22)
MAINTENANCE CONTINUED
Figure 16
Figure 17
Figure 18
Figure 19
Figure 20
Figure 21
A
D
B
C
C
Figure 22
