0715 IH-2268
PAGE 4 OF 7
3. To return to floor cleaning, rotate the valve towards
the front of the cleaner until the indicator points to
the floor setting. Replace the wand into the lower
retainer and secure into the wand clip. The cleaner
is equipped with a wand device that prevents the
wand from being stored until the suction control
valve is set to the floor position. (See Figure 10)
4. To extend the cleaning reach of the wand, push the
dark gray button nearest the handle, and pull down
on the outer wand section. Reverse the process
before returning the wand to the storage position.
(See Figure 11)
5. The wand assembly has a built-in crevice tool and a
permanently attached dusting brush.
6. To engage the dusting brush, press the dark gray
button and slide the brush over the crevice tool until it
locks. Reverse the process for storage. (See Figure 12)
CHANGING THE DUST BAG
1. Pull up on the dust bin cover latch release and fully
open the cover to expose the bag. (See Figure 13)
2. Pull the dust bag straight up to remove. Insert new
bag and close the cover, making sure the latch
locks into the handle. (See Figure 14)
NOTE: the dust bag cover will not latch without
a dust bag installed.
CAUTION! Turn off the switch and unplug the
electrical cord before maintenance.
IMPORTANT! Improper installation of the brush
roll or brush roll belt could cause carpet or
carpet or cleaner damage.
HOW TO REPLACE THE HEPA FILTER ASSEMBLY
1. Pull down on the filter assembly latch to release.
(See Figure 15)
HOW TO USE CONTINUED
Figure 11
Figure 13
MAINTENANCE
Figure 14
Figure 15
Figure 12
Figure 10
