06/2006
9
www.U-LineService.com
2175DWRWC — Drawer Model Wine Captain
®
Minor Adjustment:
Note:
The mounting holes
on the slide are slightly
larger than the screws’
diameter.
1. Loosen the slide’s
mounting screws.
2. Push the slide
backward.
3. Retighten the screws.
See
Figure 9
.
Severe Adjustment:
Note:
The slides have
extra mounting holes that
may be used.
1. Remove the slide’s
mounting screws.
2. Reposition the slide so
it is the same distance
from the front of the
liner as the other slide.
Measure to confirm.
3. Mark new drilling holes
using different sets of mounting holes on the slide. See
Figure 10
.
Note:
Front location holes are shown. Corresponding rear
holes will also need to be marked.
4. Drill all the new holes with a #30 drill bit.
5. Remount the slide.
Front-to-Back Adjustment
See
Figure 11
. The drawer
will need a Front-to-Back
Adjustment if, when
viewed from the side, the
drawer front is cocked
forward or back. This is
caused by the front slide
mountings not being level
with the rear slide
mountings.
Minor Adjustment:
Note:
The mounting holes
on the slide are slightly
larger than the screws’
diameter.
1. Loosen one slide’s
mounting screws.
2. Level the slide.
3. Retighten the screws.
See
Figure 12
.
4. Repeat procedure for
the other slide.
Severe Adjustment:
Note:
The slides have
extra mounting holes that
may be used.
1. Loosen one slide’s rear
mounting screws.
2. Remove the slide’s
front mounting screws.
3. Reposition the slide so
it is level.
4. Mark new front drilling
holes using a different
set of mounting holes on the slide. See
Figure 13
.
5. Drill the new holes with a #30 drill bit.
6. Remount the slide.
7. Repeat procedure for the other slide.
Push Slide
Backward
Loosen
Mounting Screws
Figure 9
Mark and Drill New
Mounting Holes
Push Slide
Backward
Figure 10
Not Aligned Front-to-Back
Side View of Unit
Figure 11
Screws Should
Be Loose
Level the Slide
Figure 12
-hndl
Mark and Drill New
Mounting Holes
Level the Slide
Figure 13
