C099-F9P - User Guide
UBX-18055649 - R02
Firmware updates
Page 33 of 48
Download a u-blox configuration file for the ODIN-W2 module. The “u-blox ODIN-W2 BT Rover.txt” file
is the default configuration shipped with the C099 - see Appendix B.
Figure 53: Selecting File > Download Configuration
Figure 54: Selecting u-blox ODIN-W2 BT Rover.txt file
Select the file and click Open. It will download the file and write it to Flash.
☞
The ODIN-W2 UART will now be set to 460800 baud in Data default mode. It will be ready for use
again.
Disconnect s-center from the ODIN-W2 port and power the C099-F9P off and on to ensure it will be
using the new configurations as default.
Position a jumper at “OE3” for Bluetooth operation.
The rover is now ready to connect to PC or Mobile via Bluetooth SPP.
The board is now ready for use for the wireless connection examples described in the earlier sections.
When untethered operation is not required, the ZED-F9P dedicated USB connection on the C099 can
be used for suppling corrections and monitoring/ logging purposes with u-center.
Summary of Contents for C099-F9P
