TYROLIT Hydrostress TBE400, Operating Instructions Manual

Page: 10 / 31

10
THE RIP GUIDE
Steps to use the 45º / 90º rip guide
1. Set the rip guide by positioning it on the desired dimension and tighten the threaded
knob. Make sure that the rip guide is firmly tightened to avoid slippage. The rip guide
can be used for 90º rip cuts and 45º angle cuts from both the left and right side.
(Note the straight and 45º angled slits on the bottom of the rip guide
2. After the rip guide is positioned for the desired cut, place material flat against the rip
guide and the measurement rail. After the rip guide is positioned for the desired cut,
place material flat against the rip guide and the measurement rail. For 45º rip cuts,
place the corner of material in the open slot of the measurement rail.
3. Simply line up the material being cut with the appropriate pre-marked lines on the
cutting table.
4. Now you are ready to make your cut
CUTTING DEPTH
The recommended cutting depth is 0.6cm (¼") below the cutting table surface. The
cutting clearance has been fixed from original designed.
Only use the Ø16" (400 mm) blade for this saw. Setting smaller size of
diamond blade may grab the material being cut, causing damage and
possibly injury.
max. Blade Diameter max. Cutting Depth
400 mm 125 mm