HYCON HRS Ring Saw
HYCON A/S • Juelstrupparken 11 • DK-9530 Støvring • Tel +45 9647 5200
2
Specifications
HRS Ring Saw
Weight w/o hoses
and disc
10.9 kg
Oil flow
30-40 l.p.m.
Recommended water
supply
4 l.p.m. / 2 bar
Working pressure
nominal
160 bar
Pressure relief valve in
power source
Max. 250 bar
Max. return pressure
40 bar
Max. oil temperature
80°C
Disc diameter
400 mm
Max. cutting depth
300 mm
Circumferential speed
37–49 m/s
Vibration level
<2.5m/s²
Sound pressure level
1 m L
PA
109 dB(A)
Sound Power level L
WA
98 dB(A)
Necessary cooling
capacity on power
source
1 kW
Power
4.7 kW
Safety Precautions
•
Read the HRS ring saw and power source operating manuals prior to use.
•
Only use the HRS ring saw in accordance with the local working regulations
on allowed working time
•
Check the oil flow to the HRS ring saw. The oil flow may not exceed 40
l.p.m. A too high oil supply can result in the speed of the diamond disc
being too high, causing the disc to break.
•
Make sure that the diamond disc is mounted correctly and firmly fastened.
•
Always use diamond discs approved for handheld cutting and for the
material to be cut.
•
Always use discs that are in good condition.
•
From the factory, the HRS ring saw is mounted with a safety trigger, which
may never be disturbed or dismounted.
•
The HRS ring saw has an automatic integrated security that makes the saw
stop if the diamond disc jams. However, in case of jamming, always loosen
the disc from the material, before you start cutting again.
•
Start the HRS ring saw just before you start cutting, and stop it again once
the cutting is done. Do not let the HRS ring saw run freely in the air without
water supply.
•
In case of horizontal cutting or cutting above the head, always be aware of
material falling down.
•
A fine jet of oil at pressure can penetrate the skin. It is therefore important
never to use your fingers to check for oil leaks and never to hold your face
close to suspected leaks – use a piece of cardboard instead. If oil has
penetrated the skin, you should get medical treatment immediately.
•
Never leave the HRS ring saw when connected to the powerpack.
•
Always use approved hoses. Contact your dealer, if necessary. Mount the
hoses correctly so that the HRS ring saw rotates in the right direction. The
hydraulic motor will be destroyed if pressure is set to the wrong connection.
(T)
•
The operator must pay extra attention and show caution when working in
difficult working areas, such as slopes and other dangerous nature of the
ground. Do not reach too far with the HRS ring saw, but always maintain a
good footing and keep your balance.
•
The operator must be properly trained in using the HRS ring saw or under
supervision of a qualified instructor.
•
The operator must always use protective goggles, earplugs, hard hat and
shoes when operating the HRS ring saw.
Summary of Contents for HYCON HRS 5806
Page 16: ......
