TYROLIT
Hydrostress AG
Page 20
Ring saw HRG500
Cutting
Position disk grinding ring below the centre. Always start cutting with the disk grinding ring ro-
tating.
WARNING
Risk of injury from sudden ring saw recoil.
X
Do not apply disk grinding ring above the middle of a workpiece edge.
Cutting technique
It is more economical to divide the entire cutting depth into several cuts.
–
For optimum guidance, first make a 50 to 70 mm cut.
–
Divide the entire cut depth into several cuts.
Terminating the work
1.
Switch off motor using the stop switch
2.
Close off water supply and disconnect.
3.
Blow out water from all lines.
4.
Clean ring saw with water.
6.1.2
6.2
