Installation and commissioning
8
.09
8
.09.01
Basic position of the machine drive unit
On machines with Typical-EcoDrive and control unit P40 ED
● Switch on the machine.
● Press the
TE/speed key tw ice
to select the input mode.
● Select parameter "798" by pressing the corresponding
+ /- key,
and select service level
C,
see Chapter
Selecting the user level
in the instruction manual for the control panel.
● By pressing the corresponding
+ /- key
select the parameter "799" (Selecting the machine
class).
● Check whether value "2" is set, and correct it if necessary.
If the parameter has to be altered, operate the
TE/Speed
key and then switch
off the machine and switch it on again. Then select service level
C
again as de-
scribed above.
● By pressing the corresponding
+ /- key,
select parameter "800" (selecting the sewing
direction).
● By pressing the corresponding
+ /- key,
select the value for the parameter at "1".
● By pressing the corresponding
+ /- key,
select parameter "700".
● Sew a stitch by operating the pedal.
● Turn the balance wheel in the sewing direction until the descending needle is level with
the top edge of the needle plate.
● Then check the parameter values listed in the parameter list (see Chapter
10.07 Parameter Settings)
and adjust them if necessary.
● Conclude the adjustment of the sewing motor by pressing the
TE/Speed key.
29