If you are using your printer with a Voltage other than 110 Volts you will need to switch the current setting
on the power supply. This is an easy and safe procedure as long as it is done properly.
First turn the machine around to look at the back.
Remove the small panel Marked PSU ACCESS by unscrewing the thumbscrews on the
back of the machines – it’s the one with the plug and switch in it (figure 4.2.1).
Do not disconnect any wires, there is enough slack in the cables to allow switching. Mid way down on the
power supply through the metal grating you will see a switch with numbers on it. There will also be a yellow
sticker on the power supply indicating voltage and switch positions. Your switch will be set to 115V.
Using the included hexagonal wrench, move the switch to 230V position (figure 4.2.1). You should hear a
click. Double check the switch is all the way over to 230V and not between settings. Your power supply is
now set. Replace the electronics cover.
Figure 4.2. 2
Figure 4.2. 1
