Doc No. FM0804 issue 4 Page 32
Pin No.
Cat5e Wire Colour
1
White/Orange
2
Orange
3
White/Green
4
Blue
5
White/Blue
6
Green
7
White/Brown
8
Brown
21.
MANAGER’S DISPLAY PANEL
INSTALLATION
The optional XT2
Manager’s Display Panel (P/No. ZXT
905) is a wall
mounted 10.1
”
Windows 10 touch-screen PC.
This is will display alarm calls and log all system activity with the time
and date. It can also be used for setting up system features, software
updates and to allocate Telecare devices.
The Manager’s Display Panel
can
have a large “Notice B
oard
”
monitor
connected to display information for residents in communal areas.
Up to 32
Manager’s
Display Panels can be connected per system.
Each panel requires a local mains supply and an Ethernet connection to
the XT2 controller. An Ethernet Switch will be required on installations
with more than one panel.
PANEL CONNECTIONS
POWER SUPPLY
The Manager’s Display Panel
should be located within close proximity of a mains supply where the PSU module can be
plugged-in and connected to the
DC-IN
port. The PSU module has a 0.8 metre long mains lead plus a 1.8 metre low
voltage lead
–
this must not be cut down or extended.
Note: the Manager’s Display Panel has no battery standby and is
therefore not operational during a mains failure.
ETHERNET
If there’s only one Manager’s Display Panel
and it’s within 3 metres cable run of the Advent XT2 controller then
connect the
LAN
port to the XT2
Ethernet 1
(CON3) using the 3m
CROSSOVER
Patch Lead provided.
If there
’
s only one
Manager’s Di
splay Panel but it
’
s a distance away, then an RJ45 wall socket should be fitted locally
to the XT2 controller and Manager
’
s Panel and wired between using Cat5e Ethernet U/UTP cable (Belden Type:
1583E.00B100) or equivalent. Wire all 8 connections between the wall sockets, the max cable length must not exceed
100 metres
. Use the 3m Crossover Patch Lead at the XT2 end and the standard 2m Patch Lead at the Panel end.
If there’s multiple Manager’s Display
Panels, then an Ethernet Switch will be required. Connect the XT2 Ethernet 1
port and each Panel to the Ethernet Switch using local RJ45 wall sockets and standard 2m Patch Leads. Wire between
the RJ45 wall sockets as described above. A 5 Port Ethernet Switch (Tynetec P/No. W07485) can be used for up to 4
panels, larger switches are available.
4
5
8
7
3
6
2
1
P10280 TYPE "A"
CUT BOTH RESISTORS OFF PCB
4
5
8
7
3
6
2
1
P10280 TYPE "B"
NO RESISTORS BUT DIFFERENT PIN-OUT
PSU Module
DC-IN = Power Supply Connection
LAN = Ethernet Connection to XT2 Controller
HDMI = Video Output for a Notice Board display
LINE-OUT = Audio Output
RJ45 Wall Socket
5 Port Ethernet Switch
USB = Connection for USB devices
