TYM T1054, Operator'S Manual

Page: 132 / 204

5 - 10
MAINTENANCE
J10O516A J10O517A
Indicator
High-pressure
filter
Hydraulic oil
filter
Engine oil filter
cartridge
J10O518A
5. rEplACINg fIlTEr ANd CArTrIdgE
rEplACINg TrANsMIssION
hydrAulIC OIl fIlTEr
①
Remove the hydraulic oil filter el -
ement by turning it counterclock-
wise with a wrench.
② Apply a thin film of oil to the O-ring
of a new cartridge and install the
new cartridge by tightening it with
a hand. When its packing touches
the sealing surface, turn it approx.
2/3 turns further with a wrench.
③ Add the specified amount of hy -
draulic oil.
④ Check the oil level with the dipstick
again. If still insufficient, add more.
► rEplACINg ANd sErvICINg
hIgh-prEssurE fIlTEr
①
When the indicator is turned on in
red after the engine is started, the
element needs to be replaced.
②
Stop the engine and turn the
cover counterclockwise with a
spanner to remove it.
③ Pull down the cartridge to remove it.
④ Replace the element.
⑤ Apply a thin film of oil to the
O-ring and push it up to fit it.
⑥ Wash the removed cover with
hydraulic oil and install it with a
spanner.
⑦
Start the engine and confirm that
the indicator is turned on in green.
► rEplACINg ENgINE OIl fIl-
TEr CArTrIdgE
①
Remove the engine oil filter car -
tridge by turning it counterclock-
wise with a wrench.
② Apply a thin film of oil to the
O-ring of a new cartridge and in-
stall the new cartridge by tight-
ening it with a hand. When its
packing touches the sealing sur-
face, turn it approx. 2/3 turns fur-
ther with a wrench.
③ Add the specified amount of en -
gine oil.
►