Tyco iSTAR eX, Installation And Configuration Manual

Page: 46 / 232

iSTAR eX Tools
1–26 iSTAR eX Installation and Configuration Guide
Configuring Controllers
Use the ICU to configure a controller’s IP addresses, connection type, and
identity information.
You can also use the ICU to change a controller’s identity, for example, from
master to member, and to modify a controller’s IP addresses.
Viewing Controller Status
If a controller in the ICU’s subnet is powered on, the utility displays the
following information for the controller:
„
MAC address
„
Name
„
IP address
„
Parent’s IP address (either the host or master controller IP address)
„
Type of controller
„
Connection status
iSTAR Web-Based Diagnostic Utility
The Web-based Diagnostic Utility permits using the Web to view iSTAR eX
status and diagnostics information from any networked computer. The iSTAR
web-based diagnostic utility provides:
„
Password protection
„
Internet access to iSTAR eX controllers
„
Diagnostic tools for troubleshooting and monitoring system activity
At system startup, the C•CURE host downloads IP address information to
the master. To ensure proper configuration, the information that you enter
in the ICU must match the information that you configure in C•CURE.
NOTE
The iSTAR Web-Based Diagnostic Utility has not been evaluated by UL.