http://www.tyan.com
96
Appendix 2
LSI Ultra2 LVD SCSI
supplying termination at the other end of the bus is shut down. By default, the
motherboard is built with the onboard termination Enabled.
5. Installing Smybios 53C896 SCSI Software
To install the 53C896 SCSI software (drivers), go to the section below for the
operating system installed on your computer (for example, Computers with
Windows 95/98). If the operating system is not yet installed, install it now.
Refer to your operating system documentation for instructions.
NOTE:
If you have installed a new SCSI hard drive in a computer running
Windows or DOS, you must partition and format the drive with the DOS
FDISK and FORMAT commands before it can be used. Refer to your
Windows and DOS documentation for instructions.
Computers with Windows 98/95 Installed
1.
Click on the Start Button on the Task bar and Select Settings, Control Panel.
Under the Control Panel, select System, Device Manager, Other Devices.
2.
Double click the PCI SCSI bus controller
3.
Click on Driver and then Update Driver buttons.
4.
Click Next
5.
Select Search for a better driver than the one your device is using now
6.
Click Next and select Specify a location
7.
At the command prompt, type
A:\
and click Next. Where A: is the
Symbios 53C896 driver disk provided by Tyan.
8.
Windows will copy driver from the floppy disk.
9.
Repeat the steps above for the secondary SCSI channel.
10.
Reboot the system when prompted.
12.
Repeat the steps above for secondary SCSI channel.
13.
Reboot the system when prompted.
Computers with Windows NT Installed
1.
Use the three floppy disks that come with Windows NT 4.0 for installation.
2.
After the second floppy disk finishes loading, NT will ask for a mass
storage device. At this point, you can have Windows NT install the
!
important!
