Chapter 2: Setting Up
17
2.1
Rack Mounting
After installing the necessary components, the Tank GT20
can be mounted in a rack using the supplied rack mounting
kit.
Rack mounting kit
Sliding Rails x 2:
Sliding Brackets x 4 (Front x 2, Rear x 2)
Mounting Ears x 2
Screws Kit x 1
Mounting Brackets x 4
2.1.1 Installing the Server in a Rack
Follow these instructions to mount the Tank GT20 into an
industry standard 19" rack.
NOTE
: Before mounting the Tank GT20 in a rack, ensure that
all internal components have been installed and that the unit
has been fully tested. Maintenance can be performed on the
unit while in a rack but it is preferable to install the device in a
fully operational condition.
Screws List
(including screws for SMDC)
A: Flat 6#-32 x4~x16
B: B-type 6#-32 x4
C: M4-4L x8
D: M4-5L x4
E: M4-8L x8
F: M4-15L x2
G: 13.5mm stand-off x1
A
B
C
D
E
F
G
Summary of Contents for Tank GT20 (B5372-H)
