TYAN S5365, Manual

Page: 66 / 79

66
70H TP_ERROR_MSGS Displays any errors found.
72H TP_TEST_CONFIG Checks for bad configurations.
74H TP_RTC_TEST (Optional)
76H TP_KEYBOARD Reports if there was a keyboard or
controller failure.
7AH TP_KEYLOCK (Optional)
7CH TP_HW_INTS Initializes hardware interrupt
vectors.
7DH TP_ISM_INIT (Optional)
7EH TP_COPROC Tests for coprocessor.
80H TP_IO_BEFORE (Optional)
81H TP_LATE_DEVICE_INIT POST device initialization routine.
(Optional)
82H TP_RS232 (Optional)
83H TP_FDISK_CFG_IDE Configures Non-MCD IDE
controllers.
84H TP_LPT (Optional)
85H TP_PCI_PCC Configures PnP PCC devices.
(Optional)
86H TP_IO_AFTER (Optional)
87H TP_MCD_INIT Configures MCD devices.
88H TP_BIOS_INIT Initializes timeouts, key buffer, soft
reset flag.
89H TP_ENABLE_NMI Enable NMIs.
8AH TP_INIT_EXT_BDA Initializes extended BIOS data
area.
8BH TP_MOUSE Checks if mouse is installed,
displays “Installed” message.
(Optional)
8CH TP_FLOPPY POST task for installing and
initializing legacy floppy disk
drives.
8EH TP_AUTOTYPE (Optional)
8FH TP_FDISK_FAST_PREINIT (Optional)
90H TP_FDISK Tests hard disks.
91H TP_FDISK_FAST_INIT Programs timing registers
according to PIO modes.
(Optional)
92H TP_USERPATCH2 Jump to UserPatch2.
93H TP_MP_INIT Creates the MP table. (Optional)
95H TP_CD Installs CD-ROM for boot.
(Optional)