Tiger i7525 (S2672)
Chapter 2: Board Installation
http://www.tyan.com
24
3.11 – Installing the Power Supply
Power connectors
Tiger i7525 (S2672) board supports EPS/12V power supply unit (PSU) with three power
connectors listed below.
EPS/12V Power Connectors
+
24-pin system power connector
8-pin CPU power connector
(split CPU power planes)
Optional Power Connector for a x16 PCI-Express graphic card
This optional 6-pin power connector is designed for
providing additional power to a x16 PCI-Express graphic
card. If your power supply does not have this optional 6-
pin power connector, you may use the power split cables.
Usually the graphic card company provides the power
split cables for your PCI-Express graphic card, if
necessary. Check your graphic card user’s manual for its
power requirements.
NOTE
You
MUST
unplug the power supply before plugging in the 20-pin and 8-pin
power cables to motherboard connectors.
3.12 – Finishing Up
Congratulations on making it this far! You’re finished setting up the hardware aspect of your
computer. Before closing up your chassis, make sure that all cables and wires are connected
properly, especially IDE cables and most importantly, jumpers. You may have difficulty powering
on your system if the motherboard jumpers are not set correctly.
In the rare circumstance that you have experienced difficulty, you can find help by asking your
vendor for assistance. If they are not available for assistance, please find setup information and
documentation online at our website or by
calling your vendor’s support line.
