Thunder 2500 S1867
37
If a new user is added to a 100 Mbps switching hub, the new station receives its own
dedicated 100 Mbps link and doesnt impact the 100 Mbps bandwidth of another station.
Switching hubs can effectively increase the overall bandwidth available on the network,
significantly improving performance. Switching hubs can also support full duplex.
For more information on Fast Ethernet, visit the Network Products website (http://
www.intel.com/network).
Creative Labs Sound Drivers Installation Note
For S1867 Win NT 4.0 / Win98
Creative Labs ES1373 PCI Sound Setup
Note: This note assumes drive D: for your CDROM drive.
1) Go to the following directory path:
D:\Audio\S1867\drivers\setup\english
2) Select (double-click) sbsetup.exe - Setup window will appear with Sound
Blaster Setup Options. The two options are Remove Only and Remove
and Install Software. The default setting is Remove and Install Software.
Use the default setting and click Next.
3) Click Next again. The installation will begin and autodetection of hard
ware and drivers will follow.
4) Click the Finish button and reboot the computer.
Frequently Asked Questions
Q:
My system sometimes has no display. How should I check the system?
A:
Check to see if the DIMM is REGISTERED. Also, the first thing to do is to check and
see if you have any device conflict in I/O address, IRQ, or DMA. If you are using Windows
95/98, the Device Manager is a good place to start. Please consult your operating system
manual for details. Second of all, slowing down the memory timing in the BIOSs chipset
setup section will help the situation, as well. Many memory modules are not suitable for
high performance systems and are probably the main source of your problem.
Q:
Why dont I get a display after I put in my old DIMM module?
A:
The SeverSet HE chipset requires the memory manufacturer to program an EEPROM
chip with
SPD
(Serial Presence Detection) on the module in order for the BIOS to
program the chipsets timing registers properly. Your DIMM may not have the EEPROM
chip on the module, or the EEPROM may not contain the correct program. Make sure
that the DIMM is Registered.
INST
A
LL
procedure
1.
2.
3.
168-pin Registered DIMM
