Twin Eagles TEBQ30G-C, Installation Use And Care Manual

Page: 25 / 36

20
CLEANING & MAINTENANCE
IMPORTANT
Stainless Steel & General Product Care
To keep your TWIN EAGLES products free of surface corrosion and in good working order, it is important
to take additional precautions under certain conditions.
If your TWIN EAGLES products are located in corrosive conditions, such as:

A coastal environment where corrosive salty air is present.

Near a swimming pool, hot tub or water feature with exposure to corrosive pool chemicals and/or
chlorinated water.

Areas where muriatic acid (hydrochloric acid) or other corrosive cleaning solutions are used to clean
concrete and masonry.

Areas where corrosive masonry dust and debris are created by cutting stone or mixing cements.
These conditions can create a highly corrosive environment that will cause the corrosions resistant type 304
stainless steel to develop surface oxidation, corrosions or rust.
TWIN EAGLES products have been tested in saline solutions, highly chlorinated solutions and have been
tested against exposure to highly acidic foods. The test results proved the type 304 stainless steel can
withstand exposure over prolonged periods of time. However, the conditions outlined above, along with
neglect, can lead to surface corrosion or rust.
It is recommended that your TWIN EAGLES products be kept dry and covered when not in use. This is even
more important when long-term storage is intended.
Do not allow food particles or grease to be left inside your TWIN EAGLES products. These can attract
rodents, which are unsanitary and are likely to cause physical damage by chewing on the wiring, which can
cause permanent damage to the electrical components.
If you are located along the coast or in the desert, wind driven sand is extremely abrasive and can pit and
scratch the stainless steel. Keep your TWIN EAGLES products covered when not in use.
When routine cleaning, maintenance and awareness of the conditions outlined above, you can enjoy many
years of service from your TWIN EAGLES products.
In the event that surface corrosion has developed on the stainless steel, it is typically not the stainless steel
that is corroding but corrosive particles that have been deposited on the surface.
TWIN EAGLES
grills are made of all welded stainless steel. It is non-rusting and non-magnetic. Never clean
the stainless steel when it is hot. After the initial grilling use, certain areas of the grill may discolor. This is a
normal discoloration caused by the intense heat given off by the burners.