17
Match/BBQ Lighter Lighting Instructions:
If there is no electrical power supply available or if hot surface igniter
will not light the burners, the burners can be lit manually using a
lighted long match, taper or BBQ lighter.
1.
Push and turn the knob counter-clock-wise to the biggest flame
marking on the bezel. Hold the knob pushed in for 5 seconds.
2.
Insert a lit match or BBQ lighter through the grates and near the
top of the flashtube. Once you see or hear a flame you can
release the knob.
Important
: If burner fails to light within 5 seconds, turn off gas
and wait 5 minutes before repeating the process.
Warning
: If you smell gas, shutoff the gas supply and
immediately check for leaks using the soapy water technique (Pg
7).
INSERT MATCH/
BBQ LIGHTER
USING THE GRILL
1.
Check to be certain that the drip pan is in place and pushed all the way back into the grill.
2.
Light the grill burners using the instructions in use and care manual (Pg 16).
3.
Turn the control knobs to HI and allow the grill to preheat for 15 minutes or until desired
temperature is displayed on the thermometer. The hood is to be closed during the appliance preheat
period.
4.
Place the food on the grill and cook to the desired temperature doneness. Adjust heat setting, if
necessary. The control knob may be set to any position between HI and LO.
5.
Allow grill to cool and clean the drip pan after each use.
INTERIOR LIGHT OPERATION
The Twin Eagles grill is equipped with two interior halogen lights and decorative knob LED lights for late
night grilling. The grill is equipped with a hood switch that allows the interior lights to shut-off
automatically when closing the hood.
1.
Push the switch located on the front panel to turn ON interior and knob lights.
WARNING:
Do not touch the interior halogen lights. They may be hot and can cause serious burns.
REPLACING INTERIOR LIGHT BULBS
WARNING!
Unplug the grill from the 120V power source before replacing the light bulb.
1.
Gently pop the lens cover out.
2.
Remove the old light bulb by pulling it straight out of the socket without twisting the light bulb.
3.
Wearing plastic gloves, insert the new light bulb into the socket.
DO NOT
touch bulb with bare hands
as the oil and dirt will shorten bulb life. (Bulb is small with two prongs, 12V/10W, don’t handle without
gloves)
4.
Gently push the lens cover back into the light assembly.
Summary of Contents for TEBQ30G-C
Page 28: ...23 EXPLODED VIEW ...
Page 31: ...26 WIRING DIAGRAM ...