The Apache RTR 160 4V with ABS does an automatic
self check every time the ignition switch is turned
‘ON’. The ABS warning lamp provided at the
speedometer console blinks and informs you that the
ABS is under check.
It is not necessary to have this pulsation feel every
time the brake is applied. Pulsations are felt only
during wheel locking tendency, occurs due to the
modulation of pressure in the brake circuit by HECU.
Pulsation means that the vehicle is in limit. This
pulsation feel also depends on the road condition.
t
Perform the periodic maintenance as per the
schedule.
DO‘S AND DON'T‘S
Do’s
This ABS warning lamps goes ‘OFF’ once the bike
reache 6 km/h
s
speed and above and ABS warning
lamp will blink whenever vehicle speed is less than
6 km/h indicating that the ABS is working fine. If the
warning lamp is continuously ‘ON’ even after the
vehicle crossing
speed then ABS has an error
6 km/h
and your bike should be taken to any of your nearest
TVS Motor Company Authorised Distributors or
Dealers / Authorised Service Centers.
t
Check the ABS warning lamp for any warning
before driving the vehicle.
t
Apply both front and rear brake for better
performance.
t
Apply continuous brake in ABS mode for better
performance. Do not pump.
t
ABS should be serviced only at TVS Motor
Company Authorised Distributors or Dealers /
Authorised Service Centers.
t
Carefully remove the front wheel during puncture
/ tyre replacement to prevent toner ring damage /
bend.
04
SINGLE CHANNEL ANTI-LOCK BRAKING SYSTEM
