C2-160 & C2-260 O
PERATION
M
ANUAL
63
11.5.2 Loading Logos
Figure 13 Logo Loader
To program a logo into the unit select the ‘Logos’ tab from the image programmer
screen and then press
Load Image.
You can select JPEG, BMP and GIF images. The image will be loaded and shown
on the screen. You should then enter a name for the Logo – this name, limited to
24 characters, will be shown on the unit when it is selected.
The Logo number is the ‘slot’ that the Logo will be loaded into within the unit, there
are between 10 and 15 ‘slots’ available depending on the unit type.
If you do not need to key out any part of the logo then simply press ‘Program’
Pressing program will convert the image into its raw RGB values and then
compress it, if the image is too large once compressed then the programming
sequence will stop and report that the image is too large / complex.
To key part of the image select the ‘Keyer’ checkbox. You can now use the mouse
right and left click to select up to two colours to key from the image. Pressing
‘preview key’ effects will refresh the image showing the keyed areas as transparent.
The ‘Invert preview background’ checkbox will for preview purposes add a
background to keyed image to allow for easier key adjustments.
Should the edges of the keyed portions of the image still show shades of the Key
colour then the softness adjustment should be altered until the required key effect
is reached. If the softness adjustment is not sufficient then selecting the ‘Edge
filter’ option will detect edges of the key areas and apply further softness.
Once programmed if the logo is too large on the unit output then adjust the ‘Logo
shrink’ and reprogram the logo.
