7
4.2
1T-CT-400 Series Transmitters
1. Connect the source device’s video output to the VIDEO IN connector of the
Transmitter, using the appropriate cable. All models except the 1T-CT-453 have
a VIDEO OUT connector that can provide a loop-thru signal to a local monitor.
2. All Transmitter models, except the 1T-CT-441, have audio capability. Connect
either the source device’s analog stereo or S/PDIF audio output to the either the
STEREO IN connector or the S/PDIF IN connector of the Transmitter (1T-CT-467
does not have S/PDIF in). Do not connect both as this will result in interference
between the two. The system is designed to support either audio format, but not
both at the same time. The audio output of the Transmitter can provide an
analog stereo signal for local monitor. If a S/PDIF input is used, this will be
converted to analog stereo for this purpose.
3. Connect a Cat.5/5E or Cat.6 cable to the UTP OUT connector of the Transmitter.
Model 1T-CT-467 has 8 UTP Outputs. All Transmitter models support up to 300
meters (1,000’) of CAT.5/5E or CAT.6 premium grade network cables as
described in 4.1 above. Model 1T-CT-467 has 8 UTP Outputs. The Receiver
model determines the maximum distance of either 150 meters (500’) or 300
meters (1,000’) of the cable as cam be determined by checking section 4.3
below.
Note – In addition to these three Transmitter models mentioned about, TV One
Models C2-1200 and C2-1250 Video Switcher/Scalers have built-in UTP transmitters
capable of sending either RGBHV or YPbPr format signals (without audio) up to
1000 feet. Consult the manual for those units when they are being used.
Summary of Contents for 1T-CT-400 Series
Page 1: ...Instruction Manual 1T CT 400 Series Cat 5 Extenders...
Page 2: ......
