10
.
If you want to nudge the blue image to the left, make sure the blue LED is blinking, then
hold the nudge button in and wait until the blue LED is blinking. Then tap the Nudge Left
button repeatedly. Each tap will result in a tiny incremental move to the left. There are
32 increments in this adjustment. To shift the blue image to the right, make sure the
blue LED is still blinking and tap the Nudge Right button repeatedly. To adjust the Red
and Green images, repeat the process, making sure the color you want to adjust is
blinking. Adjust the Skew controls until the Red, Blue and Green images are vertically
aligned and the white vertical lines show no prismatic halos. When complete, release
the adjustment buttons and in 30 seconds the LED will stop blinking and the Receiver
reverts to normal operation and the Skew adjustment settings are retained in memory.
6.0 TROUBLESHOOTING
Other than faulty cables or attempting to use the product over too great of distances,
there are seldom problems with these Video Extender products.
If there is no image present at the remote location, connect the display device directly to
the source to make certain that the problem is not in the display. If an image is present
under those circumstances, make certain the transmitter and receiver(s) are receiving
power. Next make certain your Cat.5/5E/6 cable is defect free and the RJ-45 connectors
are securely attached to the cable at both ends.
After trying the above suggestions should the problem still persist, contact your dealer
for additional suggestions before contacting TV One. Should the dealer’s technical
personnel be unable to assist you, contact TV One via our support website:
http://tvone.crmdesk.com.
Create a technical support request on the site and our
support team will respond within a short period of time.
Locate the RGB Skew Adjust buttons on the side of
the Receiver. While watching the remote display,
press and HOLD either RGB skew adjust button. After
three seconds, the RGB adjust indicator LED starts
blinking; Receiver is now in RGB Skew Adjust Mode.
The color of the blinking LED indicates the color being
adjusted. Colors cycle if you hold the button down
steadily.
Summary of Contents for 1T-CT-400 Series
Page 1: ...Instruction Manual 1T CT 400 Series Cat 5 Extenders...
Page 2: ......
